Proudly Support
Recent News
Nicole Johnson Sponsorship
Anaheim, CA – April 1st, 2009 As Ready Welder entered the 2009 year, the organization knew it was..Read more
As Seen In














Product Information Chart
Not sure which Ready Welder model is right for you?
• Use the chart below to find the Ready Welder model that best suits your needs.
• Click the model number on the left to expand features.
• Alternatively, roll over the feature to find the matching welders.
RW Model
Number
Connects to
Batteries
Connects to
CV MIG Machines
Connects to
CC ARC/
Stick Machines
Has Extended
20' Leads
Integrated
Ground Clamp
Features Safety
"Cold Start"
10000
10000ADP
10250
10000-CS
10000ADP-CS
100250-CS
Product Features
For a listing of the full details of accessories included with each model, click on the model image in which you are interested.
Model #10000
  • Specifically cabled for standard battery connection
  • Includes quick disconnect plugs, ground cable and clamp for maximum portability
  • Will connect to constant voltage MIG machines.
Model #10000ADP
  • Includes AC/DC power supply to allow connection to CC/Stick Machines
  • Will also connect to batteries
Model #10250
  • Connects to all DC output welding machines as a spool gun
  • AC/DC power supply provided for motor control when connected
    to CC/Stick Machines
  • LC 10 type connectors
  • Does not include ground clamp
Model #10000MDP-CS "Military Pak"
NEW (GSA) NSN #: 5130-01-522-1379
  • Four Spools of Wire
    - 2 Flux Core Wire (Steel)
    - 2 Aluminum
  • Two 20FT extensions
  • Waterproof, airtight and heavy-duty tough case
  • Integrated 15' cable
  • Extra Circuit Board Assembly
  • NATO Power Plug
  • Integrated Cold Switch already included
  • More Detailed Information & Content List
Cold Switch Option
This option can be added to any one of our Ready Welder II models above. The Cold Switch solenoid system is contained in a softball sized box that is integrated near the end of the Ready Welder II's cable and adds approximately 3' to the overall cable length. This system is designed to protect the operator from accidentally striking an arc without the trigger pulled. The solenoid is deactivated when you release the trigger, allowing you to lay the welder down or to avoid arcing out your grounded surfaces without any worries. This feature was manufactured with safety in mind. To add this option, simply add "-CS" to the end of the model number.