|
 Proudly Support |
| Recent News |
| Nicole Johnson Sponsorship | | Anaheim, CA – April 1st, 2009
As Ready Welder entered the 2009 year, the organization knew it was..Read more |
|
| As Seen In |
|
  |
| Model #10000 |
 The RWII Model #10000 is cabled best for battery operation. This model will also connect to all CV (constant voltage) and DC (direct current) output machines. This model is most frequently used by repairmen, maintenance workers, 4X4 off-road enthusiasts, ranchers, boaters, agricultural industry and anyone primarily using batteries as the power source.
The ground cable is attached to the red dual quick disconnect connectors. This makes welding jobs in remote locations easy, portable and quick. This model will run off any 18, 24 & 36 volt batteries in a parallel series depending on the application and material to be welded. The Model #10000 has a one year 100% parts and labor limited factory warranty. |
| 10000 Features |
Ready Welder II Case Includes |
- Welds
Steel,
Stainless
and Aluminum
or Any
Metals Where
Standard One
or Two Pound
Spools are
Available
- Connects
to Batteries
– 18 Volts can
do Thin
Sheet Metal
– 24 Volts
will Single
Pass
1/2"
@ 275 amp
– 36 Volts
will Weld up
to 3/4"
@ 350 to 400
amp
- Welds
22 Gauge to
3/4"
- Connects
to MIG/Constant
Voltage
Output
Welders
- Uses
Wire Sizes
from .023 to
.040 without
changing
rollers.
- Uses
Heavy-Duty
TWECO
Quality
Front End
Consumables
- Wire
Speeds of 50
Inches to
900 Inches
per Minute
- Polarity
Indicator
Lights
- Ten
Foot Cable
with Quick
Disconnects,
Can be
Extended to
80 Feet
- Built-in
Gas Valve
- Ground
Cable
Attached
|
- RWII
High-Impact
MIG Gun
- Ten
Feet of
Cable
- One
Spool of
Flux Core
Wire
- 300
Amp Ground
Clamp
- Two
Battery
Clamps
- Extra
Tips and Gas
Hose Fitting
- Ten
Extra Feet
of Gas Hose
- Foam
Lined
Blow-Molded
Tough
Briefcase
|
|
|
|
